Re: [CAD_CAM_EDM_DRO] 3 Phase drive
Posted by
Spehro Pefhany
on 2001-08-28 13:08:26 UTC
At 07:12 PM 8/28/01 +0000, you wrote:
then discontinued. I wasted a bit of time ($$$$) on that one 8-(
Most everyone is going with microcontrollers these days. Not very
hobby friendly, but that's the way it is.
Best regards,
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
Spehro Pefhany --"it's the network..." "The Journey is the reward"
speff@... Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog Info for designers: http://www.speff.com
Contributions invited->The AVR-gcc FAQ is at: http://www.bluecollarlinux.com
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
>Gee, I just looked at their web site, and can't find any mention of theI think you are right, it was sold to another company (Fairchild?) and
>44xx series of parts at all. I wonder if they sold this product line to
>another company.
then discontinued. I wasted a bit of time ($$$$) on that one 8-(
Most everyone is going with microcontrollers these days. Not very
hobby friendly, but that's the way it is.
Best regards,
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
Spehro Pefhany --"it's the network..." "The Journey is the reward"
speff@... Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog Info for designers: http://www.speff.com
Contributions invited->The AVR-gcc FAQ is at: http://www.bluecollarlinux.com
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
Discussion Thread
riet91@y...
2001-08-27 23:25:16 UTC
3 Phase drive
Jon Elson
2001-08-28 13:02:50 UTC
Re: [CAD_CAM_EDM_DRO] 3 Phase drive
Spehro Pefhany
2001-08-28 13:08:26 UTC
Re: [CAD_CAM_EDM_DRO] 3 Phase drive
Jon Elson
2001-08-28 20:21:31 UTC
Re: [CAD_CAM_EDM_DRO] 3 Phase drive
riet91@y...
2001-08-29 03:36:32 UTC
Re: 3 Phase drive
Jon Elson
2001-08-29 21:41:38 UTC
Re: [CAD_CAM_EDM_DRO] Re: 3 Phase drive
Flavio Luiz
2001-08-30 01:56:40 UTC
Re: [CAD_CAM_EDM_DRO] 3 Phase drive
Jon Elson
2001-08-30 10:40:20 UTC
Re: [CAD_CAM_EDM_DRO] 3 Phase drive
Eric Keller
2001-08-31 16:23:04 UTC
Re: [CAD_CAM_EDM_DRO] 3 Phase drive