Re: @$#%&* Installation!!!!
Posted by
drew@x...
on 1999-10-08 14:23:05 UTC
Hi Clint,
Although it's none of my buisness I think you might want to
recalculate the x/y moves for the R-8 taper. I get an x move
of 0.147 over a length of 1.000 in z. Remember that the 16 deg
51 min. angle is the included angle therefore you want half
of that for the angle from the centerline of the spindle.
I would also try for a move which is closer to the correct
angle. A 10 min. difference in the included angle gives a
difference of about 0.0015 in x over the 1 inch move in z.
Please excuse me if I'm wrong. It's happened before but I'd
hate to see someone mess up their spindle.
Drew
Although it's none of my buisness I think you might want to
recalculate the x/y moves for the R-8 taper. I get an x move
of 0.147 over a length of 1.000 in z. Remember that the 16 deg
51 min. angle is the included angle therefore you want half
of that for the angle from the centerline of the spindle.
I would also try for a move which is closer to the correct
angle. A 10 min. difference in the included angle gives a
difference of about 0.0015 in x over the 1 inch move in z.
Please excuse me if I'm wrong. It's happened before but I'd
hate to see someone mess up their spindle.
Drew
On Oct 8, 11:45am, Clint Bach wrote:
> Subject: Re: [CAD_CAM_EDM_DRO] @$#%&* Installation!!!!
> From: Clint Bach <clintbach@...>
>
> I may give the emc thing a break for a short time while I digest the
> problems and determine a direction to go. I was delighted to get the
> emc simulation running. At leasty I'm confident the problem is with
> rtlinux and not emc. I'm working on getting my spinldle made into R-8
> collets. That part is going well. I determined the taper of the cone
> part is 16 degrees 51 minutes. 3 inches in 10 inches equalls 16 degrees
> 41 minutes so I will just use that ratio to cut the taper. I can move
> the x axis .300 inches and the z axis 1.000 inches with a G 01 movement
> and should get a working taper.
>
> Thanks, Clint Bach
>-- End of excerpt from Clint Bach
--
Drew Rogge
drew@...
Discussion Thread
Clint Bach
1999-10-07 04:58:27 UTC
@$#%&* Installation!!!!
stratton@x...
1999-10-07 11:18:01 UTC
Re: @$#%&* Installation!!!!
Ray Henry
1999-10-08 08:19:22 UTC
@$#%&* Installation!!!!
Clint Bach
1999-10-08 08:45:56 UTC
Re: @$#%&* Installation!!!!
Jon Elson
1999-10-08 12:49:49 UTC
Re: @$#%&* Installation!!!!
drew@x...
1999-10-08 14:23:05 UTC
Re: @$#%&* Installation!!!!
Paul Corner
1999-10-08 15:46:26 UTC
Re: @$#%&* Installation!!!!
Clint Bach
1999-10-08 12:59:26 UTC
Re: @$#%&* Installation!!!!
PTENGIN@x...
1999-10-08 19:38:57 UTC
Re: @$#%&* Installation!!!!
Clint Bach
1999-10-10 16:39:18 UTC
Re: @$#%&* Installation!!!!