Re: @$#%&* Installation!!!!
Posted by
Clint Bach
on 1999-10-10 16:39:18 UTC
GOOD NEWS!
I have a spindle withan R-8 collet system!!! 0.147 inch to 1.000 inch
did the trick completely and totally. No problems. Good grip and
everything works well. I haven't checked the runout but it seem to be
really good!
Thanks for the help...
Clint Bach
Paul Corner wrote:
I have a spindle withan R-8 collet system!!! 0.147 inch to 1.000 inch
did the trick completely and totally. No problems. Good grip and
everything works well. I haven't checked the runout but it seem to be
really good!
Thanks for the help...
Clint Bach
Paul Corner wrote:
>
> From: Paul Corner <Paul.Corner@...>
>
> > I'm working on getting my spinldle made into R-8
> > collets. That part is going well. I determined the taper of the cone
> > part is 16 degrees 51 minutes. 3 inches in 10 inches equalls 16 degrees
> > 41 minutes so I will just use that ratio to cut the taper.
>
> Hi Clint.
>
> I've got two drawings for R8 tapers. One from Tubal Cain's Model Engineers
> Hanbook. The taper is quoted as 16 deg 51 min included. The second drawing is
> in an old Bridgeport manual, here the taper is given as 3 1/2 inches per foot
> included.
> Hope this helps.
>
> Regards, Paul.
>
> > Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager
Discussion Thread
Clint Bach
1999-10-07 04:58:27 UTC
@$#%&* Installation!!!!
stratton@x...
1999-10-07 11:18:01 UTC
Re: @$#%&* Installation!!!!
Ray Henry
1999-10-08 08:19:22 UTC
@$#%&* Installation!!!!
Clint Bach
1999-10-08 08:45:56 UTC
Re: @$#%&* Installation!!!!
Jon Elson
1999-10-08 12:49:49 UTC
Re: @$#%&* Installation!!!!
drew@x...
1999-10-08 14:23:05 UTC
Re: @$#%&* Installation!!!!
Paul Corner
1999-10-08 15:46:26 UTC
Re: @$#%&* Installation!!!!
Clint Bach
1999-10-08 12:59:26 UTC
Re: @$#%&* Installation!!!!
PTENGIN@x...
1999-10-08 19:38:57 UTC
Re: @$#%&* Installation!!!!
Clint Bach
1999-10-10 16:39:18 UTC
Re: @$#%&* Installation!!!!