3D digitizer table
Posted by
Doug Fortune
on 2001-09-29 19:04:50 UTC
Colin <cdoughty@...> wrote:
I am planning to have a digitizer option on my upcoming
XXYZ router table kits. I am going with a commercial-type
probe (interpret that as an 'expensive' option, realistically
around $1K range). However, it will give CMM (co-ordinate
measuring machine) performance if your mill or router table
is that precise (ie 1/10 of a thou or better).
Homebrew type probes have been discussed here (CCED forum)
early this spring, but I doubt whether any of those designs
are in the above performance catagory.... (and obviously
they don't have to be for many hobby purposes).
Doug Fortune
http://www.cncKITS.com
> Has any one got plains to build a 3D digitizer table.Hi Colin:
> any ideas please.
I am planning to have a digitizer option on my upcoming
XXYZ router table kits. I am going with a commercial-type
probe (interpret that as an 'expensive' option, realistically
around $1K range). However, it will give CMM (co-ordinate
measuring machine) performance if your mill or router table
is that precise (ie 1/10 of a thou or better).
Homebrew type probes have been discussed here (CCED forum)
early this spring, but I doubt whether any of those designs
are in the above performance catagory.... (and obviously
they don't have to be for many hobby purposes).
Doug Fortune
http://www.cncKITS.com
Discussion Thread
Doug Fortune
2001-09-29 19:04:50 UTC
3D digitizer table
Iain Ward
2001-09-29 22:52:11 UTC
Re: [CAD_CAM_EDM_DRO] 3D digitizer table
Alan Marconett KM6VV
2001-09-30 12:25:42 UTC
Re: [CAD_CAM_EDM_DRO] 3D digitizer table
shymu@b...
2001-09-30 18:32:15 UTC
Re: 3D digitizer table
Alan Marconett KM6VV
2001-10-01 11:06:49 UTC
Re: 3D digitizer table