Re: Still a little unclear
Posted by
Skarsaune@x...
on 1999-05-20 18:02:41 UTC
Delurking....
I'm a manufacturing engineer by trade & full time occupation, and in my 2nd
full time job I run my own machine shop. I've got a 1977 vintage Hurco CNC,
servo based, 2.5 axis, on Bridgeport iron, and an Emco Compact 5 CNC lathe
(very small, stepper driven, nice unit). And a LARGE assortment of manual
machine tools of all varieties.
I've been lurking 'cause I haven't had a lot to say, and I'm too busy,
mostly.
I'm interested in doing CNC on the cheap, either retrofitting old machines,
or
grafting servos/steppers onto manual machines. My current need is for a
larger CNC lathe, and I'm still weighing the buy/make decision.
Back to work & lurk now,
Chuck Skarsaune
Oaktree Machine & Engineering
Colbert, GA
I'm a manufacturing engineer by trade & full time occupation, and in my 2nd
full time job I run my own machine shop. I've got a 1977 vintage Hurco CNC,
servo based, 2.5 axis, on Bridgeport iron, and an Emco Compact 5 CNC lathe
(very small, stepper driven, nice unit). And a LARGE assortment of manual
machine tools of all varieties.
I've been lurking 'cause I haven't had a lot to say, and I'm too busy,
mostly.
I'm interested in doing CNC on the cheap, either retrofitting old machines,
or
grafting servos/steppers onto manual machines. My current need is for a
larger CNC lathe, and I'm still weighing the buy/make decision.
Back to work & lurk now,
Chuck Skarsaune
Oaktree Machine & Engineering
Colbert, GA
Discussion Thread
Don Hughes
1999-05-19 22:22:47 UTC
Still a little unclear
Jonty50@x...
1999-05-19 22:50:43 UTC
Re: Still a little unclear
Don Hughes
1999-05-19 23:00:10 UTC
Re: Still a little unclear
Roger Mason
1999-05-20 03:20:33 UTC
Re: Still a little unclear
HillofSpud@a...
1999-05-20 05:46:42 UTC
Re: Still a little unclear
Mark Fraser
1999-05-20 06:21:29 UTC
Re: Still a little unclear
Dan Mauch
1999-05-20 07:01:44 UTC
Re: Still a little unclear
Brian Fairey
1999-05-20 08:54:32 UTC
Re: Still a little unclear
Jonty50@a...
1999-05-20 09:20:00 UTC
Re: Still a little unclear
Jonty50@a...
1999-05-20 09:20:02 UTC
Re: Still a little unclear
WAnliker@a...
1999-05-20 09:39:50 UTC
Re: Still a little unclear
Don Hughes
1999-05-20 10:31:27 UTC
Re: Still a little unclear
Jon Elson
1999-05-20 11:24:28 UTC
Re: Still a little unclear
Skarsaune@x...
1999-05-20 18:02:41 UTC
Re: Still a little unclear
Dan Mauch
1999-05-21 06:08:44 UTC
Re: Still a little unclear
Buchanan, James (Jim)
1999-05-24 12:29:40 UTC
Re: Still a little unclear