Re: [CAD_CAM_EDM_DRO] Re: Gear milling

In a message dated 10/3/2001 8:32:10 AM Pacific Daylight Time,
shabm@... writes:

> hypoide.
>

Regular gears are involute, the ring and pinion of a car rear end are I think
the Hypoide. For the Involute if done properly you can make 5 cuts per tooth
with a cutter shape of a rack, Do one at the center, and two one pitch apart
higher and same lower, they will modify the tooth to a fairly close involute
for smaller gear sizes.
bill



[Non-text portions of this message have been removed]