Re: [CAD_CAM_EDM_DRO] Re: Gear milling

Hi
yes
it makes by Hobbing machine.
involute is automatically generated by hobbing.
SHABBIR

At 12:58 PM 10/3/01 -0400, you wrote:

>In a message dated 10/3/2001 8:32:10 AM Pacific Daylight Time,
>shabm@... writes:
>
>
>> hypoide.
>>
>
>Regular gears are involute, the ring and pinion of a car rear end are I

think

>the Hypoide. For the Involute if done properly you can make 5 cuts per

tooth

>with a cutter shape of a rack, Do one at the center, and two one pitch apart
>higher and same lower, they will modify the tooth to a fairly close involute
>for smaller gear sizes.
>bill
>
>
>
>[Non-text portions of this message have been removed]
>
>
>Addresses:
>FAQ: http://www.ktmarketing.com/faq.html
>FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
>Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, walker@...
>Moderator: jmelson@... timg@... [Moderator]
>URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>bill,
>List Manager
>
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>