Re: [CAD_CAM_EDM_DRO] Newby Question : DRO and Interpreter software

paulernestca@... wrote:

> Was wandering if I could use the interpreter software as a DRO since
> I am converting my mill to CNC and also in the process now to install
> linear strip with and U.S. DIgital encoder connected to a Dan Mauch &
> Tom Kulaga Dro card. I am confuse, can an interpreter software by use
> as a DRO in manual milling, (may be two different thing). Because I
> see interpreter screen with X, Y, Z, and number scrolling when I use
> arrows on keyboard right left up down, software like Master 5 Can the
> servo encoder give reference of the axis when turning by hand.

EMC, when connected to encoders, can be used as a DRO. i think
there are easier ways to go, but this will work.

Jon