Re: Bridgeport BOSS 6

The one I found uses 18 - 80 volts max 20 amp, max step frequency 1MHz and
has gain and damping trim pots. Cost $800.00 for each axis.
Darrell

----- Original Message -----
From: Bob Bachman <bobach@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: Tuesday, October 12, 1999 8:24 PM
Subject: Re: [CAD_CAM_EDM_DRO] Bridgeport BOSS 6


> From: Bob Bachman <bobach@...>
>
> Darrell,
>
> What is the scope on the 'step/direction input - servo output units'?
>
> Bob
>
> At 02:46 PM 10/12/99 -0700, you wrote:
> >From: "Darrell Gehlsen" <darrell@...>
> (big snip)
> >I am still looking for a servo interface. I have a lathe that has servos
and
> >I am running it with the ahha software with some step/direction input
servo
> >output units.
> >The price is a little high to my way of thinking so I will keep looking.
> >Darrell
> >
>
> > Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>