Re: Bridgeport BOSS 6

Bob,
Yeah, I'm still looking too. The lathe that I have on this system didn't
have any amps when I got it, just the servos and encoders so I went for
these units as I could build the rest.
Darrell

----- Original Message -----
From: Bob Bachman <bobach@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: Tuesday, October 12, 1999 9:01 PM
Subject: Re: [CAD_CAM_EDM_DRO] Bridgeport BOSS 6


> From: Bob Bachman <bobach@...>
>
> Darrell,
>
> I don't need driver/amps. I need something to take the step/direction
> signals from the parport and convert it to the analog +-10v to drive
> my servo/amps and read the feedback from the scales. Like Servo-to-go
> only cheaper.
>
> Bob
>
> At 05:52 PM 10/12/99 -0700, you wrote:
> >From: "Darrell Gehlsen" <darrell@...>
> >
> >The one I found uses 18 - 80 volts max 20 amp, max step frequency 1MHz
and
> >has gain and damping trim pots. Cost $800.00 for each axis.
> >Darrell
> >
>
> > Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>