CAD CAM EDM DRO - Yahoo Group Archive

Re: Bridgeport BOSS 6

Posted by Bob Bachman
on 1999-10-12 21:01:15 UTC
Darrell,

I don't need driver/amps. I need something to take the step/direction
signals from the parport and convert it to the analog +-10v to drive
my servo/amps and read the feedback from the scales. Like Servo-to-go
only cheaper.

Bob

At 05:52 PM 10/12/99 -0700, you wrote:
>From: "Darrell Gehlsen" <darrell@...>
>
>The one I found uses 18 - 80 volts max 20 amp, max step frequency 1MHz and
>has gain and damping trim pots. Cost $800.00 for each axis.
>Darrell
>

Discussion Thread

Darrell Gehlsen 1999-10-12 14:46:54 UTC Re: Bridgeport BOSS 6 Matt Shaver 1999-10-12 16:41:41 UTC Re: Bridgeport BOSS 6 Darrell Gehlsen 1999-10-12 16:59:42 UTC Re: Bridgeport BOSS 6 Bob Bachman 1999-10-12 20:24:48 UTC Re: Bridgeport BOSS 6 Darrell Gehlsen 1999-10-12 17:52:28 UTC Re: Bridgeport BOSS 6 Bob Bachman 1999-10-12 20:46:57 UTC Re: Bridgeport BOSS 6 Bob Bachman 1999-10-12 21:01:15 UTC Re: Bridgeport BOSS 6 Darrell Gehlsen 1999-10-12 18:24:40 UTC Re: Bridgeport BOSS 6 john@x... 1999-10-13 03:41:16 UTC Re: Bridgeport BOSS 6