Re: [CAD_CAM_EDM_DRO] routing acrylic/plexiglass

Carl,

Stay with the O flute bits, go clockwise for the outside cuts and
counterclockwise for the inside cuts. 70 inches per minute is a good place
to start.

Bob Campbell

----- Original Message -----
From: <carlcnc@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Friday, October 26, 2001 8:32 PM
Subject: [CAD_CAM_EDM_DRO] routing acrylic/plexiglass


> A local sign shop has asked me to cut some stuff from 1/4" acrylic.
> I checked several manufacturers web sites for speeds and feeds.
> Came up with "nada"
> anyone have suggestions or rule of thumb for sfm,type of cutters
> -O-flute?]
> thanks
> Carl
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>