Re: Re: DON'T CUT THOSE WIRES !! and My CNC Mill retrofit project
Posted by
Darrell Gehlsen
on 1999-10-13 13:02:13 UTC
<snip>
You are right about two of the wires being current +/- but I think the other
two are tachometer wires.
Darrell
><snip/>
> I looked into one of the motors, and was surprised to see only 4 contacts,
> 2 of which seemed to be the DC current + and - and 2 which came from a
> gizmo on the back which I assume was the encoder. If the things have
> tachometers they are must be someplace else- or can speed be calculated
> from the encoder pulses?]
>
You are right about two of the wires being current +/- but I think the other
two are tachometer wires.
Darrell
Discussion Thread
Andrew Werby
1999-10-13 04:04:58 UTC
Re: DON'T CUT THOSE WIRES !! and My CNC Mill retrofit project
Darrell Gehlsen
1999-10-13 13:02:13 UTC
Re: Re: DON'T CUT THOSE WIRES !! and My CNC Mill retrofit project