CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] What router to get?

Posted by HighTech
on 2001-10-31 20:25:00 UTC
Would both of you, Chris and Doug think that the 3.25hp Porter Cable
be a good choice. The range is only 10k to 21k in 5 steps but I have heard
that it holds its speed very good even using a big bit. But that is all I
know of it and I can get a good price $299 on a 7539.
Or is the Bosch listed below better it is cheaper.
Derek

-----Original Message-----
From: Chris L

Doug Fortune wrote:

(snip)

The magnesium framed Bosch 1617EVS 2 amp

> (2 HP, 8,000-25,000 rpm) - the brochure says
> they are quiet and the EVS circuitry maintains
> the selected speed (which is a bit hard to believe,
> but it may be so, within limits).

I will add that it is the quietest conventional 2 hp router I have ever had.
Well, that is until you get her "barkin" in a chunk of material !

And it does a very good job at maintaining rpm as it runs into different
densitys like wood knots and what nots........

Chris L




Addresses:
FAQ: http://www.ktmarketing.com/faq.html
FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/

Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
Moderator: jmelson@... timg@... [Moderator]
URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
bill,
List Manager



Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

Discussion Thread

HighTech 2001-10-31 19:34:45 UTC What router to get? Doug Fortune 2001-10-31 19:54:33 UTC What router to get? Chris L 2001-10-31 19:56:04 UTC Re: [CAD_CAM_EDM_DRO] What router to get? Chris L 2001-10-31 20:03:21 UTC Re: [CAD_CAM_EDM_DRO] What router to get? HighTech 2001-10-31 20:25:00 UTC RE: [CAD_CAM_EDM_DRO] What router to get? Doug Fortune 2001-10-31 20:39:02 UTC Re: [CAD_CAM_EDM_DRO] What router to get? Craig Chamberlin 2001-10-31 20:44:01 UTC Re: [CAD_CAM_EDM_DRO] What router to get? zeff1015@a... 2001-11-01 04:48:23 UTC Re: [CAD_CAM_EDM_DRO] What router to get? HighTech 2001-11-01 07:58:17 UTC RE: [CAD_CAM_EDM_DRO] What router to get? CL 2001-11-01 10:00:49 UTC Re: [CAD_CAM_EDM_DRO] What router to get?