Encoder wiring question.
Posted by
wayne_j_hill@y...
on 2001-11-07 11:03:06 UTC
Hello All,
(I have searched the FAQ area before asking this question.)
I am turning the path from steppers to DC servos. Right now I am
experimenting with simple testing. I have purchased a GeckoDrive 340
and a used DC motor (2.5" dia X 5.0" w/.375 shaft) with an encoder
attached. My question is the encoder did not have pinout
information. There are 10 pins on it. I have determined the +5VDC
and ground pins from the IC's on the circuit. How do I find the
Phase A and Phase B pins and the Quad resolution of the encoder?
Have not applied power to anything yet.
TIA,
Wayne
(I have searched the FAQ area before asking this question.)
I am turning the path from steppers to DC servos. Right now I am
experimenting with simple testing. I have purchased a GeckoDrive 340
and a used DC motor (2.5" dia X 5.0" w/.375 shaft) with an encoder
attached. My question is the encoder did not have pinout
information. There are 10 pins on it. I have determined the +5VDC
and ground pins from the IC's on the circuit. How do I find the
Phase A and Phase B pins and the Quad resolution of the encoder?
Have not applied power to anything yet.
TIA,
Wayne
Discussion Thread
wayne_j_hill@y...
2001-11-07 11:03:06 UTC
Encoder wiring question.
Alan Marconett KM6VV
2001-11-07 12:13:51 UTC
Re: [CAD_CAM_EDM_DRO] Encoder wiring question.
JanRwl@A...
2001-11-07 21:05:17 UTC
Re: [CAD_CAM_EDM_DRO] Encoder wiring question.
Jon Elson
2001-11-07 21:42:56 UTC
Re: [CAD_CAM_EDM_DRO] Encoder wiring question.
ballendo@y...
2001-11-08 17:35:01 UTC
Re: Encoder wiring question.
wayne_j_hill@y...
2001-11-08 21:28:27 UTC
Re: Encoder wiring question.
wayne_j_hill@y...
2001-11-08 21:32:06 UTC
Re: Encoder wiring question.