Re: Encoder wiring question.

Ballendo,

The servo is made by Hathaway and the encoder is made by Sensor
Technology, Inc. No information on the Internet at Hathaway's web
site. Did not find Sensor Technology's site.

Thank's to everyone for the reply's. I have enough information to
determine what to do next.

Wayne

--- In CAD_CAM_EDM_DRO@y..., ballendo@y... wrote:
> Wayne,
>
> You've already gotten some good "technical" answers, so I'll just
mention that most encoder pinouts are now online at various
electronics supply sites. Did you look for a part number?
>
> Hope this helps.
>
> Ballendo
>
> --- In CAD_CAM_EDM_DRO@y..., wayne_j_hill@y... wrote:
> > Hello All,
> >
> > (I have searched the FAQ area before asking this question.)
> >
> > I am turning the path from steppers to DC servos. Right now I am
> > experimenting with simple testing. I have purchased a GeckoDrive
340
> > and a used DC motor (2.5" dia X 5.0" w/.375 shaft) with an
encoder
> > attached. My question is the encoder did not have pinout
> > information. There are 10 pins on it. I have determined the
+5VDC
> > and ground pins from the IC's on the circuit. How do I find the
> > Phase A and Phase B pins and the Quad resolution of the
encoder?
> > Have not applied power to anything yet.
> >
> > TIA,
> >
> > Wayne