RE: [CAD_CAM_EDM_DRO] Re: master 5 control software
Posted by
Tim
on 2001-12-06 12:33:14 UTC
Just be aware that Master5 is limited in steps to about 8000 per second.
That means you would likely need G340 drives not G320 drives and the
step increment would be dictated by the multiplier setting.
Tim
[Denver, CO]
That means you would likely need G340 drives not G320 drives and the
step increment would be dictated by the multiplier setting.
Tim
[Denver, CO]
> -----Original Message-----
>
> Zoomer,
> Maybe you can use Gecko servo drives... input Master5
> step/direction and hook the MaxNC motors and encoders to the
> Gecko??? Art?
>
Discussion Thread
zoomer199
2001-12-05 22:10:52 UTC
master 5 control software
Art Fenerty
2001-12-06 10:44:07 UTC
Re: [CAD_CAM_EDM_DRO] master 5 control software
zoomer199
2001-12-06 11:27:35 UTC
Re: master 5 control software
Art Fenerty
2001-12-06 11:38:38 UTC
Re: [CAD_CAM_EDM_DRO] Re: master 5 control software
Gail & Bryan Harries
2001-12-06 12:27:57 UTC
RE: [CAD_CAM_EDM_DRO] Re: master 5 control software
Tim
2001-12-06 12:33:14 UTC
RE: [CAD_CAM_EDM_DRO] Re: master 5 control software
Art Fenerty
2001-12-06 13:16:30 UTC
Re: [CAD_CAM_EDM_DRO] Re: master 5 control software