CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: master 5 control software

Posted by Art Fenerty
on 2001-12-06 11:38:38 UTC
Hi Zoomer:

Normally, I would send this off-list, but as others have discussed the CL
series here, I thought I'd share what little I know.
It seems to be a 3 axis servo PWM controlled system. I have checked what
comes from the printer port during initialization and it seems to try to
home at turn on, looking for home switches as it puts out a pulse width
modulated pulse on one pin. If I simulate the home switch, it then repeats
on another pin. So the upshot is, the system seems to be a pulse width speed
control with home switch pins. This makes it incompatible with all
controlers I've ever heard of with the exception of the MaxNC it came with.
I do not use servo's however, so perhaps some of the servo experts here can
help you find a controller which will output PWM to the motors.

Good luck,
Art
Master5 Software
http://users.andara.com/~fenerty/master.htm

Discussion Thread

zoomer199 2001-12-05 22:10:52 UTC master 5 control software Art Fenerty 2001-12-06 10:44:07 UTC Re: [CAD_CAM_EDM_DRO] master 5 control software zoomer199 2001-12-06 11:27:35 UTC Re: master 5 control software Art Fenerty 2001-12-06 11:38:38 UTC Re: [CAD_CAM_EDM_DRO] Re: master 5 control software Gail & Bryan Harries 2001-12-06 12:27:57 UTC RE: [CAD_CAM_EDM_DRO] Re: master 5 control software Tim 2001-12-06 12:33:14 UTC RE: [CAD_CAM_EDM_DRO] Re: master 5 control software Art Fenerty 2001-12-06 13:16:30 UTC Re: [CAD_CAM_EDM_DRO] Re: master 5 control software