Re: [CAD_CAM_EDM_DRO] Re: master 5 control software

Gecko's would work fine I think. Speed wont be an issue. Tims right, but on
a MaxNC, my users tell me that .5 inches per second is as fast as their
machine can go even with the MaxNC software, so 8192 is no limitation on a
Max NC which uses 8000 pulses per inch, you only need 4092 pulses per second
to max out the machines capability.

Art
Master5 Software
http://users.andara.com/~fenerty/master.htm

----- Original Message -----
From: "Tim" <timg@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Thursday, December 06, 2001 3:33 PM
Subject: RE: [CAD_CAM_EDM_DRO] Re: master 5 control software


> Just be aware that Master5 is limited in steps to about 8000 per second.
> That means you would likely need G340 drives not G320 drives and the
> step increment would be dictated by the multiplier setting.
>
> Tim
> [Denver, CO]
>
> > -----Original Message-----
> >
> > Zoomer,
> > Maybe you can use Gecko servo drives... input Master5
> > step/direction and hook the MaxNC motors and encoders to the
> > Gecko??? Art?
> >
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>