CAD CAM EDM DRO - Yahoo Group Archive

Re: THREADED ROD

Posted by woodknack
on 2001-12-15 06:23:56 UTC
--- In CAD_CAM_EDM_DRO@y..., "Dan Mauch" <dmauch@s...> wrote:
> Try going to the local fastener store listed in the yellow pages.
Ask
> them for B7 threaded rod. This material has rolled threads which are
> infinitely better quality than die cut threads. Then while you're
there
> ask for 1/4-20 coupling nuts. These nuts are several times longer
than a
> standard nut and because of this tend to have near zero backlash.
Total
> cost for a 3ft length of rolled all thread and three coupling nuts
will
> be about $4.
> Dan
> Thanks, Thats just what I planned on doing. I love this page great
source of info. thanks again!
>
> -----Original Message-----
> From: woodknack [mailto:wjdupont@h...]
> Sent: Friday, December 14, 2001 2:24 PM
> To: CAD_CAM_EDM_DRO@y...
> Subject: [CAD_CAM_EDM_DRO] THREADED ROD
>
> I am building a unit like the PCB Mill. Its going to use 1/4-20
> threaded rod to move the axasis. My question is, Is there a certain
> quality rod I should use? Also can I Just make up for the back lash
> in my software?

Discussion Thread

woodknack 2001-12-14 14:23:37 UTC THREADED ROD cncdxf 2001-12-14 14:52:52 UTC Re: THREADED ROD captnorm3@j... 2001-12-14 15:18:33 UTC Re: [CAD_CAM_EDM_DRO] Re: THREADED ROD Sven Peter 2001-12-14 15:20:07 UTC Re: [CAD_CAM_EDM_DRO] THREADED ROD cncdxf 2001-12-14 16:01:12 UTC Re: THREADED ROD cncdxf 2001-12-14 16:13:09 UTC Re: THREADED ROD superintendent_god_botherer2000 2001-12-14 16:38:41 UTC Re: THREADED ROD Dan Mauch 2001-12-15 06:15:25 UTC RE: [CAD_CAM_EDM_DRO] THREADED ROD woodknack 2001-12-15 06:23:56 UTC Re: THREADED ROD Sven Peter 2001-12-15 06:38:00 UTC Re: [CAD_CAM_EDM_DRO] Re: THREADED ROD