Re: EMC Video drivers - help please
Posted by
awemawson
on 2001-12-27 10:23:55 UTC
--- In CAD_CAM_EDM_DRO@y..., Jon Elson <elson@p...> wrote:
I'm telling it Compaq V75 currently which will do lots of high res
modes.
(It will get something a little less modern when out in the shop, but
that what I'm using for testing)
XF86config is giving it as H = 31 to 62 Khz and V = 55 to 90 Hz
Andrew
> awemawson wrote:factor
>
> > Hi,
> >
> > I'm wallowing around trying to get the BDI set up for a higher
> > resolution than 640 x 480 - but currently it's winning !
> >
> > My system is a Compaq ENSFF PIII 800 Mhz, and being Small form
> > everything is integrated. The video chip set is an Intel FW82815choice of
> > (SL4DF = 'A2 stepping' whatever that means!)
> >
> > When I go through the BDI install and am presented with the
> > video cards the only ones I can find that work (using Test button)were
> > are generic VGA and unsupported VGA both of which give me 'virtual
> > resolution set to 640 x 480).
> >
> > The onboard graphics is supposed to be AGP4X with 8 megs of ram so
> > seeing those fuzzy chunky icons is frustrating !
> >
> > Previously I loaded it on a clone 200 Mhz PII with a 1 meg Trident
> > card (8900) and had the same symptoms, and the same two drivers
> > the only ones that worked - I had hoped that the upgrade wouldcure
> > that.generally
>
> Very strange! Trident cards are very sophisticated, and XFree86
> knows how to talk to them just fine. But, it is not JUST videocards, it
> alsobe
> includes MONITORS in the calculation of what modes can, and cannot,
> used. So, you have to tell it that you have a monitor that iscapable of
> higher resolution (or horizontal sweep rates, particularly.)Jon,
>
> Jon
I'm telling it Compaq V75 currently which will do lots of high res
modes.
(It will get something a little less modern when out in the shop, but
that what I'm using for testing)
XF86config is giving it as H = 31 to 62 Khz and V = 55 to 90 Hz
Andrew
Discussion Thread
awemawson
2001-12-27 02:51:17 UTC
EMC Video drivers - help please
fast1994gto
2001-12-27 07:12:26 UTC
Re: EMC Video drivers - help please
Jon Elson
2001-12-27 10:04:58 UTC
Re: [CAD_CAM_EDM_DRO] EMC Video drivers - help please
awemawson
2001-12-27 10:23:55 UTC
Re: EMC Video drivers - help please
Ian Wright
2001-12-27 11:28:23 UTC
Re: [CAD_CAM_EDM_DRO] Re: EMC Video drivers - help please
Paul
2001-12-27 12:46:18 UTC
Re: [CAD_CAM_EDM_DRO] EMC Video drivers - help please