CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] plastics

Posted by Matt Shaver
on 2002-01-12 18:46:18 UTC
Ian Wright wrote:

> I have been making a new mouthpiece for my euphonium out of acrylic
> (perspex, lucite?) and I have turned it from a solid 2" diameter rod. When I
> finished it and polished it it looked the bees knees and I was delighted
> but, since I have been playing on it for a few days, it has developed a
> network of fine cracks around the narrowest portion of the bore.

Using cast acrylic, rather than extruded rod, is a good suggestion.
Another possibility is to use polycarbonate (Lexan).

Is it made from tranparent (clear), or colored plastic?

Matt

Discussion Thread

Ian Wright 2002-01-12 13:30:41 UTC plastics Craig Chamberlin 2002-01-12 14:00:32 UTC Re: [CAD_CAM_EDM_DRO] plastics Spehro Pefhany 2002-01-12 14:21:24 UTC Re: [CAD_CAM_EDM_DRO] plastics Bill Vance 2002-01-12 18:19:53 UTC Re: [CAD_CAM_EDM_DRO] plastics Matt Shaver 2002-01-12 18:46:18 UTC Re: [CAD_CAM_EDM_DRO] plastics Tim Goldstein 2002-01-12 19:01:21 UTC RE: [CAD_CAM_EDM_DRO] plastics Richard Konnen 2002-01-12 20:02:10 UTC Re: [CAD_CAM_EDM_DRO] plastics zeff1015@a... 2002-01-12 20:08:10 UTC Re: [CAD_CAM_EDM_DRO] plastics Ron Kline 2002-01-13 08:07:21 UTC Re: plastics Marcus & Eva 2002-01-13 08:35:08 UTC Re: [CAD_CAM_EDM_DRO] plastics thosmurray 2002-01-13 23:08:43 UTC Re: plastics Scot Rogers 2002-01-14 01:12:22 UTC RE: [CAD_CAM_EDM_DRO] plastics asmith@a... 2002-01-14 13:08:31 UTC RE: [CAD_CAM_EDM_DRO] plastics Ian Wright 2002-01-14 14:45:34 UTC Re: [CAD_CAM_EDM_DRO] plastics Scot Rogers 2002-01-15 08:18:11 UTC RE: [CAD_CAM_EDM_DRO] plastics