CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Taig mill, Taig controller, EMC setup?

Posted by ccs@m...
on 2002-01-17 07:37:34 UTC
> Only problem is, the Taig motor controller isn't set up for
> direction/pulse, it's set up for phase output:

There may well be software fixes already written to make EMC do phase
output. If not, one of the little non-chopping stepper motor drive
chips could be used to do step-direction to phase mapping with a
little adapter board - I'd build it into the taig controller if it
were me.

Chris Stratton

-------------------------------------------------
Christopher C. Stratton
Engineer, Instrument Maker, and Horn Player
ccs@... 617 628 1062
http://web.mit.edu/~stratton/www/brassbuild.html

Discussion Thread

dk 2002-01-17 05:49:37 UTC NEW MACHINESHOP/METALWORKING GROUP sir_tancred 2002-01-17 07:02:19 UTC Re: NEW MACHINESHOP/METALWORKING GROUP sir_tancred 2002-01-17 07:05:03 UTC Opps, was Re: NEW MACHINESHOP/METALWORKING GROUP Tom Benedict 2002-01-17 07:20:25 UTC Taig mill, Taig controller, EMC setup? ccs@m... 2002-01-17 07:37:34 UTC Re: [CAD_CAM_EDM_DRO] Taig mill, Taig controller, EMC setup? Tom Benedict 2002-01-17 08:26:45 UTC Re: Taig mill, Taig controller, EMC setup? Mike Gann 2002-01-17 08:30:14 UTC Re: [CAD_CAM_EDM_DRO] Taig mill, Taig controller, EMC setup? Paul 2002-01-17 13:01:26 UTC Re: [CAD_CAM_EDM_DRO] Re: Taig mill, Taig controller, EMC setup? Brian Pitt 2002-01-17 21:05:12 UTC Re: [CAD_CAM_EDM_DRO] Re: Taig mill, Taig controller, EMC setup? Tom Benedict 2002-01-20 20:22:06 UTC Re: Taig mill, Taig controller, EMC setup?