Re: 3-axis wire-bending? - Part 2

Learned great stuff from each response to my question:

Steve - I didn't realize the bending device has one pushrod and
that the stock is rotated. Key info.

Brian F. - I wish to manipulate .008 and similar diameters of
phosphor bronze wire into scale model railroad details,
particularly the long handrailings found on diesel locomotives.
Anything in wire harnessing that could be used in my area?

Bill - I will check into spring-making methods; I have seen some
Web sites that deal with that, but I passed them by. I'll go back.

Ballendo - Existing benders might be retrofitted, you say? Are
there info resources you can point me toward?

Chris L. - I'll search for tool show locations and show dates; this
hadn't occurred to me. Do you recall the sponsor of the show you
attended?

Jan - Perhaps Austin Organ Co. will take pity on a poor Iowa boy
who cannot travel so far to investigate. Just a tip or two where to
look in the literature (if any should exist) would be well worth the
phone call.

I send you all my gratitude,

Brian Chapman