Re: [CAD_CAM_EDM_DRO] Re: Re: Re: Re: the open source 'thing'
Posted by
Chris L
on 2002-01-27 18:03:42 UTC
Shelbyville Design & Signworks wrote:
Chris L
> I was in the same situation, recently acquired an 8' x12' cybermation routerThese are the posts that will ultimately build my confidence to try EMC.
> with
> a bad controller, after a few false starts, EMC is now running extremely
> well on it.
> With just a little tweaking of the G-code driver in my software, runs like a
> champ...
Chris L
Discussion Thread
ccs@m...
2002-01-25 18:44:16 UTC
Re: the open source 'thing'
Chris L
2002-01-25 23:05:24 UTC
Re: [CAD_CAM_EDM_DRO] Re: the open source 'thing'
Ray
2002-01-26 13:43:51 UTC
Re: Re: Re: the open source 'thing'
Paul
2002-01-26 16:18:07 UTC
Re: [CAD_CAM_EDM_DRO] Re: the open source 'thing'
Chris L
2002-01-26 16:32:38 UTC
Re: [CAD_CAM_EDM_DRO] Re: Re: Re: the open source 'thing'
Chris L
2002-01-26 16:59:32 UTC
Re: [CAD_CAM_EDM_DRO] Re: the open source 'thing'
Fitch R. Williams
2002-01-27 06:48:48 UTC
Re: [CAD_CAM_EDM_DRO] Re: Re: Re: the open source 'thing'
Shelbyville Design & Signworks
2002-01-27 08:27:32 UTC
Re: Re: Re: Re: the open source 'thing'
Ray
2002-01-27 10:42:27 UTC
Re: Re: Re: Re: Re: the open source 'thing'
Chris L
2002-01-27 18:01:53 UTC
Re: [CAD_CAM_EDM_DRO] Re: Re: Re: the open source 'thing'
Chris L
2002-01-27 18:03:42 UTC
Re: [CAD_CAM_EDM_DRO] Re: Re: Re: Re: the open source 'thing'
ballendo
2002-01-28 00:48:32 UTC
Re: the open source 'thing'