Re: G02 Rx

--- In CAD_CAM_EDM_DRO@y..., "cadcamcenter" <cadcamcenter@y...> wrote:

> File>Open>.... The graphic displaced shows a series of straight
> lines, didn't see any arc. Is there another way to open NC program
> with VectorCAD that I do not know of?
>

Vector Cad does not display G-code at all. Vector CAM will allow you
to import G-code into the editor, using File-Import. You can then
Back plot the program to see the toolpath geometry that was used to
make the program.

It works very well for arcs with R values instead of I-J-K. Just
make sure that you are using a configuration that is set for R values
in arcs. This setting can be found under Options-Driver in the NC
editor.

Technical support questions about Vector should be posted on the
Vector user's forum, instead of here. It can be found at
http://www.vectorcam.com under support.

Best Regards, Fred Smith- IMService

Listserve Special discounts and offers are at:
http://www.vectorcam.com/cced2.html

We are THE source for low cost Cad Cam