Re: Electronic, off subject

Have you considered that a sensor connected to a PC might be a more
versatile solution? Otherwise I think a small microprocessor like the 6805
might be a good solution.

Marshall

----- Original Message -----
From: Tim Goldstein <timg@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: Wednesday, November 10, 1999 11:28 PM
Subject: RE: [CAD_CAM_EDM_DRO] Electronic, off subject


> From: "Tim Goldstein" <timg@...>
>
> Not in any real rush, but I would like to get it figured out in the next
> month or so. The one thing I may need different than a normal RPM meter is
I
> am looking for the actual number of turns after I reset to zero. If your
> design can do this I am all ears.
>
> Tim
> [Denver, CO]
>
> > -----Original Message-----
> > From: hansw [mailto:hansw@...]
> > Sent: Wednesday, November 10, 1999 6:25 PM
> > To: CAD_CAM_EDM_DRO@onelist.com
> > Subject: Re: [CAD_CAM_EDM_DRO] Electronic, off subject
> >
> >
> > From: hansw <hansw@...>
> >
> > Tim,
> > How quickly do you need this ?
> > I decided just last night to make a RPM counter for my mill, it should
> > do everything you need...
> > I will post the design to my web site...
> > Expect it will happen in the next 10-14 days...
> > regards
> > Hans Wedemeyer
> >
>
> > Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>