Re: EMC & RT Linux

Hans,

Sorry about the macro/subroutine mix up, sometimes I get the words mixed but the ideas straight.

I'd like to know how subroutines run on CNCPro. The algorithm I have is written in Delphi but I'm sure I could transpose the
algorithm into what ever format is required.

The laptop was a donation from a friend, I liked the idea of not having to setup a whole PC system in the workshop. I was
wondering if CNCPro would even run on a 486sx.

--
Greg Nuspel

"Research is what I'm doing when I don't know what I'm doing. "
- Wernher Von Braun (1912-1977)

Home of the BigMouth Clamp
http://www.cadvision.com/nuspelg
ICQ 13585790