Re: Help...please...BDI CD.........

I am trying this, I hope this will work
Thanks
Babar

--- In CAD_CAM_EDM_DRO@y..., Dave Lantz <dlantz@a...> wrote:
> the 'img' extension is set up for linux. it tends to not work well
with
> windows (TM) stuff. rename the file to .iso, THEN select the
option: write
> from image... probably in the file pull down menu. what you did
was to copy
> the FILE to the disk, NOT create a disk from the image... so it's
got a
> normal file system on it with the bde???.img on it right? hope that
> helps!--Dave L.
>
> -----Original Message-----
> From: riet91 [mailto:riet91@y...]
> Sent: Tuesday, February 26, 2002 3:40 AM
> To: CAD_CAM_EDM_DRO@y...
> Subject: [CAD_CAM_EDM_DRO] Help...please...BDI CD.........
>
>
> Dear List memebers ,
> I have downloaded the BDI ISO image file, extracted it with
Winimage
> software for windows and then created the CD using some CD writting
> software because my CD writing software does not open any file with
> extension img.When I tried to boot from this CD, it does not boot
> (although my system has the capability to boot from CD and it was
> properly configured to boot from CD, moreover I have also tried on
> some other systems also) .Then I made a bootable floopy from the
DOS
> utility found in the BDI CD, system booted but Linux install failed
> with the following error:
>
> "install exited abnormally... received signal 11
> sending termination signals... done
> sending kill signals.... done
> disabling swap...
> unmounting filesystem
> /mnt/source
> /dev/pts
> ejecting CD ROM
>
> Please let me know which sofware should be used for creating
bootable
> BDI CD? since normally available softwares do not open any file
with
> img extension,instead they open files with iso extension.
>
> Regards
>
> Babar
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> OFF Topic POSTS: General Machining
> http://www.metalworking.com/news_servers.html
> http://www.metalworking.com/news_servers.html
>
> Post messages: CAD_CAM_EDM_DRO@y...
> Subscribe: CAD_CAM_EDM_DRO-subscribe@y...
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@y...
> List owner: CAD_CAM_EDM_DRO-owner@y..., wanliker@a...
> Moderator: jmelson@a... timg@k... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/