CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: DIACRO BENDER QUESTION

Posted by jim davies
on 2002-03-12 18:19:59 UTC
> > Starter motor? Hadn't thought of that, are
they rated for continuous
> > duty? Don't they draw very high amperage, 50+
amps?
> >
Intermitent duty only. That was the design
breakthrough that made
Kettering rich, after all. If you can find a winch
motor [very similar
except for resistance] that would be better, or
rewire a starter motor
in series and convert to ball bearings. Or, just
keep the duty cycle
down using the palm test.

Think 70-100 amps for a 4 cylinder, 100-150 for 6
cylinder and
150-250 fro 8 cylinder starter.

Discussion Thread

stan mcdonald 2002-03-08 20:30:04 UTC DIACRO BENDER QUESTION doug98105 2002-03-08 23:00:31 UTC Re: DIACRO BENDER QUESTION Jay Hayes 2002-03-09 07:48:20 UTC Re: [CAD_CAM_EDM_DRO] Re: DIACRO BENDER QUESTION Lloyd Leung 2002-03-09 09:27:49 UTC RE: [CAD_CAM_EDM_DRO] Re: DIACRO BENDER QUESTION stan mcdonald 2002-03-12 00:08:02 UTC Re: [CAD_CAM_EDM_DRO] Re: DIACRO BENDER QUESTION stan mcdonald 2002-03-12 00:09:32 UTC Re: [CAD_CAM_EDM_DRO] Re: DIACRO BENDER QUESTION doug98105 2002-03-12 07:26:17 UTC Re: DIACRO BENDER QUESTION Sven Peter 2002-03-12 16:19:52 UTC Re: [CAD_CAM_EDM_DRO] Re: DIACRO BENDER QUESTION jim davies 2002-03-12 18:19:59 UTC Re: [CAD_CAM_EDM_DRO] Re: DIACRO BENDER QUESTION