Re: [CAD_CAM_EDM_DRO] Re: G-320 Servo current setup

In a message dated 3/19/2002 9:44:54 PM Mountain Standard Time,
mariss92705@... writes:

> If you need to read rapidly changing currents then you need an
> oscilliscope to read the voltage across the 0.01 ohm current sense
> resistor inside the drive. The scale is 1A = 10mV.
>
>

I am thinking about measuring the Gecko Chopped output, so that I can set the
amps of the servos, so what is the best way to do it?
bill


[Non-text portions of this message have been removed]