Re: G-320 Servo current setup

Hi Mariss,

Is there a similar current sense resistor in the G201's? 0.01 ohm?

Alan KM6VV


mariss92705 wrote:

>
> Bill,
>
> You can put a battery operated multimeter set to DC Amps in series
> with your motor if you are looking to read fairly steady currents.
> Your current probe will be very accurate as well.
>
> If you need to read rapidly changing currents then you need an
> oscilliscope to read the voltage across the 0.01 ohm current sense
> resistor inside the drive. The scale is 1A = 10mV.
>
> Mariss