CAD CAM EDM DRO - Yahoo Group Archive

G-320 Servo current setup

Posted by wanliker@a...
on 2002-03-19 19:53:57 UTC
How is the best way to either measure the Servo current out of the g-320's,
or to set the current limit pot. I have a DC Amp Probe, but doubt if that
would be accurate with a pulse output from the Gecko's
bill.

Discussion Thread

wanliker@a... 2002-03-19 19:53:57 UTC G-320 Servo current setup mariss92705 2002-03-19 20:43:30 UTC Re: G-320 Servo current setup wanliker@a... 2002-03-19 21:29:33 UTC Re: [CAD_CAM_EDM_DRO] Re: G-320 Servo current setup Alan Marconett KM6VV 2002-03-19 22:42:24 UTC Re: [CAD_CAM_EDM_DRO] G-320 Servo current setup Alan Marconett KM6VV 2002-03-19 22:45:27 UTC Re: G-320 Servo current setup mariss92705 2002-03-20 06:33:05 UTC Re: G-320 Servo current setup mariss92705 2002-03-20 06:51:30 UTC Re: G-320 Servo current setup wanliker@a... 2002-03-20 08:10:13 UTC Re: [CAD_CAM_EDM_DRO] Re: G-320 Servo current setup Alan Marconett KM6VV 2002-03-20 12:47:28 UTC Re: G-320 Servo current setup mariss92705 2002-03-20 12:54:27 UTC Re: G-320 Servo current setup Alan Marconett KM6VV 2002-03-20 13:42:07 UTC Re: G-320 Servo current setup