PLASMA NOISE
Posted by
Raul Lara
on 2002-03-31 16:49:25 UTC
I�m using the software to run a plasma cutter (gantry
style)
I�m getting an interference between the motors and the
plasma.
If I run the machine without the plasma, it runs very
smooth, but once I turn the plasma on the motors gets
something as an on/off pattern or like a vibration.
The plasma cut is not even, it�s something like a
small zig zag pattern.
I�m running the machine with Geckodrives G201, Pacific
Scientific stepper motors and Microkinetics PWR36
power supply.
What can I do to isolate this problem?
Best regards
Raul Lara
__________________________________________________
Do You Yahoo!?
Yahoo! Greetings - send holiday greetings for Easter, Passover
http://greetings.yahoo.com/
style)
I�m getting an interference between the motors and the
plasma.
If I run the machine without the plasma, it runs very
smooth, but once I turn the plasma on the motors gets
something as an on/off pattern or like a vibration.
The plasma cut is not even, it�s something like a
small zig zag pattern.
I�m running the machine with Geckodrives G201, Pacific
Scientific stepper motors and Microkinetics PWR36
power supply.
What can I do to isolate this problem?
Best regards
Raul Lara
__________________________________________________
Do You Yahoo!?
Yahoo! Greetings - send holiday greetings for Easter, Passover
http://greetings.yahoo.com/
Discussion Thread
Raul Lara
2002-03-31 16:49:25 UTC
PLASMA NOISE
Chris L
2002-03-31 19:07:44 UTC
Re: [CAD_CAM_EDM_DRO] PLASMA NOISE
Jon Elson
2002-03-31 23:22:03 UTC
Re: [CAD_CAM_EDM_DRO] PLASMA NOISE
aspaguy
2002-04-01 19:54:45 UTC
Re: PLASMA NOISE