Re: Machine control comparison
Posted by
carlcnc
on 2002-04-24 06:53:04 UTC
Richard
Nice thought ,but, to really have compared/tested ALL these
controllers would cost a cople thosand $$ not to mention the hours
of connecting,configuring,softwares,OS,computers.
this is probably why no single person has done a side by side [on
same machine] test.
Carl
Nice thought ,but, to really have compared/tested ALL these
controllers would cost a cople thosand $$ not to mention the hours
of connecting,configuring,softwares,OS,computers.
this is probably why no single person has done a side by side [on
same machine] test.
Carl
--- In CAD_CAM_EDM_DRO@y..., "rekmac" <rkonnen@t...> wrote:
> Has anyone done a comparison/evaluation of the different machine
> control software and interface hardware? i.e. Master5, CNCPro,
> Deskcam, EMC, Pico Systems, Flashcut, etc.... This is just a few of
> the products and there are so many good low end dollar ones out
> there, When I say low end I mean under $1000, that a pros and cons
> comparison and personal thoughts on them would be helpful to those
> (me included) putting a system together.
> Thank You,
> Richard Konnen
Discussion Thread
rekmac
2002-04-24 05:26:36 UTC
Machine control comparison
carlcnc
2002-04-24 06:53:04 UTC
Re: Machine control comparison
Richard Konnen
2002-04-24 08:21:52 UTC
Re: [CAD_CAM_EDM_DRO] Re: Machine control comparison
j.guenther
2002-04-24 08:43:53 UTC
RE: [CAD_CAM_EDM_DRO] Re: Machine control comparison
Bob Campbell
2002-04-24 17:34:49 UTC
RE: [CAD_CAM_EDM_DRO]PCI Parallel ports
vavaroutsos
2002-04-24 17:49:36 UTC
Re: Machine control comparison
Alan Marconett KM6VV
2002-04-24 20:57:05 UTC
Re: [CAD_CAM_EDM_DRO]PCI Parallel ports