Re: [CAD_CAM_EDM_DRO] XL timing belts or substitute

Bill,
Looking in my Dayco catalogue that I keep at my side, I find the
Synchro-Cog belts in 5mm pitch (which is close to the XL) in lengths up to
99.4 inches. The closes to the 96" IS the 99.4" and the next step down is 88.6"

That works out to 505 teeth for the 99.4" belt.

Hope this helps.

At 08:15 PM 4/29/02 +0000, you wrote:

>I am working on a XY table and have perhaps built myself into a
>corner. The x-axis is 48" and I was planning on using an XL
>Geartooth timing belt (96") to drive the router trolley across this
>distance. Now I find that these belts are only available up to 77
>inches. Therefore, I need suggestions on what I might use in place
>of the XL Geartooth belt.
>
>Many thanks in advance for any thoughts.
>
>Bill
>
>
>
>Addresses:
>FAQ: http://www.ktmarketing.com/faq.html
>FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
>OFF Topic POSTS: General Machining
>If you wish to post on unlimited OT subjects
>goto: aol://5863:126/rec.crafts.metalworking or go thru Google.com to
>reach it if you have trouble.
>http://www.metalworking.com/news_servers.html
>
>http://groups.yahoo.com/group/jobshophomeshop I consider this as a
>sister site to the CCED group, as many of the same members are there, for
>OT subjects, that are not allowed on the CCED list.
>
>
>
>Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
>Moderator: jmelson@... timg@... [Moderator]
>URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>bill,
>List Mom
>List Owner
>
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

Bubba

OLDER THAN DIRT
Country Bubba
(Actually the inventor of Country and Bubba)

axtein@...
LaGrange, GA

http://members.dicomm.net/~axtein


[Non-text portions of this message have been removed]