How to setup STG-II?

Hi All,
I have Installed BDI EMC version 2.09 and purchased the Servo To
go 's Model II - 8 axis Motion Control card ( STG II), I intend to
use this on a Hurco's Milling having DC Servo motors. I have
following questions in this regard:

1)Please Suggest me how to configure EMC for STG II.

2)Is the BDI EMC intall by default for LPT port? if yes how to set it
for STG-II?

3)Most of the posts I have read indicate that people are running EMC
on Pentium I systems with less then 32 MB memory, I installed on my
system which is 200 MMX with 64 MB RAM but this made my system very
slow. Have anyone run EMC on Pentium III or is it not recommended? is
there any recommended hardware list' website?

4) what will happen if BDI EMC install confilicts with any system's
hardware will it stop installation or will it install successfully
and later on during operation it may cause trouble?

Thanking you all in advance.

Babar