Deskncrt

Hi everyone,

Has any one been successful in running Deskncart
closed loop using steppers and encoders??

I only got as far as jogging. I would like to know
how to make the program run a g-code file either
through a floppy or through the C drive.

Does any one have any suggestions that worked
for them??

I've tried and followed the Deskncrt instructions
but reading inbetween the lines allmost got me cross
sighted.

Also if you got the time share some expierences
that you have with Desncrt. Like maybe trying
to figure a problem and found a solution or
a problem that never gotten solved and it's a
mystery . BIG or small. Its o;k.

You could either post it or E-mail me
at webstercnc@...

Thanks Everyone,

Juan