Re: Re: Grizzly Mini Mill

Ron,

I've bought Moglice from Devitt Machinery. I seem to have lost their
phone number, but
at least you can try searching for them. They are very helpful on the
phone, if you've
not used it before I'd recommend telling them what you are doing and
asking for advice.
I did, describing my first attempt at casting nuts (they can out way too
tight, took a lot
of lapping) and was advised to really lay on the release agent and spray
as close to square
to the thread flanks as possible. My second attempt was better, but I
still needed to lap
the nuts with Timesavers.

Jon