Re: CNC Lathe spindle motor replacement control board
Posted by
mariss92705
on 2002-06-17 11:47:29 UTC
Dan,
Here is a good source for almost everything:
http://www.motionnet.com/
Mariss
Here is a good source for almost everything:
http://www.motionnet.com/
Mariss
--- In CAD_CAM_EDM_DRO@y..., "Dan Mauch" <dmauch@s...> wrote:
> Any suggested source for a good quality low cost 90VDC speed
controller?
> My spindle motor specs are:
> 90VDC 5A continuous PM motor with tach @ 7V per 1K RPM
> 60A peak.
> Must use a speed control pot for local operation
> Must have a tach feedback for 7V/1K RPM and with good response time
for
> threading operations.
> PWM output at least 16Khz
> I would also like to have it so I can use an analog signal of +10
for
> program speed control.
> Dan
Discussion Thread
P. J. Hicks
2001-10-09 10:14:31 UTC
Re: [CAD_CAM_EDM_DRO] Digest Number 1685
ccs@m...
2001-10-09 10:31:43 UTC
Re: [CAD_CAM_EDM_DRO] Digest Number 1685
Smoke
2001-10-09 10:37:21 UTC
Re: [CAD_CAM_EDM_DRO] Digest Number 1685
Rich D.
2001-10-09 10:37:56 UTC
Re: [CAD_CAM_EDM_DRO] Digest Number 1685
Carol & Jerry Jankura
2001-10-09 12:26:53 UTC
RE: [CAD_CAM_EDM_DRO] Digest Number 1685
Dan Mauch
2002-06-17 09:36:02 UTC
CNC Lathe spindle motor replacement control board
mariss92705
2002-06-17 11:47:29 UTC
Re: CNC Lathe spindle motor replacement control board
RichD
2002-06-17 11:54:16 UTC
Re: [CAD_CAM_EDM_DRO] CNC Lathe spindle motor replacement control board
Alan Marconett KM6VV
2002-06-17 12:20:25 UTC
Re: [CAD_CAM_EDM_DRO] CNC Lathe spindle motor replacement control board