CAD CAM EDM DRO - Yahoo Group Archive

Re: power outages

on 2000-01-16 05:48:16 UTC
>From: Dan Falck <dfalck@...>
>
>Two weeks ago, I was engraving some parts, when a thunderstorm blew in
>quick and caused a small power outage- for maybe 2 seconds. My computer
>rebooted and I started cussing. While looking at the part in the fixture,
>I realized that I could just repostition the diamond bit back in the groove
>at the start of the arc segment that partially completed.

This is all well and good, but tell us about the diamond tool you are using
for engraving. I've been working with some diamond cutting tools on brass
in the lathe, and the surface finish results are amazing.

David M. Munro

Discussion Thread

Dan Falck 2000-01-16 00:00:44 UTC Re: power outages David M. Munro 2000-01-16 05:48:16 UTC Re: power outages Dan Falck 2000-01-16 07:10:00 UTC Re: power outages Rich Dean 2000-01-16 08:12:25 UTC Re: power outages Dan Falck 2000-01-16 09:55:54 UTC Re: power outages Rich Dean 2000-01-16 13:30:38 UTC Re: power outages