Re: Minimum CPU needed for EMC TNG

--- In CAD_CAM_EDM_DRO@y..., Ed Fanta <atex57@f...> wrote:

>
> I picked up a BDI a while back and have had nothing but trouble
>getting
> it to work, maybe a buggy version, probably lack of knowledge. I
>have
> been playing with RH 7.1 and like the setup better than the RH that
> comes on the BDI. The question is what is the CPU speed needed to
>run
> the TNG? I have an AMD K6III-400 running to Geckos on a Wells-Index
> mill. The mill is running at 20,000 steps per inch and 70+ inches
>per
> minute. Is the CPU fast enough? I will upgrade if needed. EMC seems
>to
> have everything I need. I really like the Yeager demo but no G41-42
>so
> it is very limited for me. TIA. Ed.

Ed, If you really want the G41-42 then have a look at TurboCNC at
www.dakeng.com

John S.