Re: DRO boards

So, I missed the earlier discussion on this item - what else will I need to
a) populate the board, and
b) drive it?

(a pointer is fine, thanks) / mark


Dan Mauch wrote:

> From: "Dan Mauch" <dmauch@...>
>
> I use the US Digital linear encoder strips mounted in a 1X2 rectangular tube
> the length of the strip. I use a tube as a pushrod and as the conduit for
> the encoder cables. Works slick.
> I will be ordering board tomorro. Better let me know if you want a board.
> Dan
> -----Original Message-----
> From: Buchanan, James (Jim) <jambuch@...>
> To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
> Date: Wednesday, May 26, 1999 6:08 PM
> Subject: Re: [CAD_CAM_EDM_DRO] DRO boards
>
> >From: "Buchanan, James (Jim)" <jambuch@...>
> >
> >Tom:
> >
> >I am just new to the list so I missed out on some earlier discussion of
> >your DRO project. I scanned your WEB page, I think it was yours, But I
> >seemed to have missed what type of encoders you are using and or
> >support. How about building your own using a type setter to make a film
> >grid.
> >
> >Thanks
> >--
> >James Buchanan
> >Lexington, Kentucky (The Blue Grass State) USA
> >Two Truck Climax Locomotive Operator & Builder
> >
> >------------------------------------------------------------------------
> >ONElist: where real people with real interests get connected.
> >http://www.onelist.com
> >Join a new list today!
> >------------------------------------------------------------------------
> >welcome to CAD_CAM_EDM_DRO@..., an unmodulated list for the
> discussion of shop built systems in the above catagories.
> >
>
> ------------------------------------------------------------------------
> ONElist: where the world talks!
> http://www.onelist.com
> Join a new list today.
> ------------------------------------------------------------------------
> welcome to CAD_CAM_EDM_DRO@..., an unmodulated list for the discussion of shop built systems in the above catagories.