Re: DRO boards

It requires just a few parts . See Tom Kulaga's discussion earlier today
about other parts required.
Dan
-----Original Message-----
From: Mark Fraser <mfraser@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Saturday, May 29, 1999 6:41 PM
Subject: Re: [CAD_CAM_EDM_DRO] DRO boards

>From: Mark Fraser <mfraser@...>
>
>So, I missed the earlier discussion on this item - what else will I need to
>a) populate the board, and
>b) drive it?
>
>(a pointer is fine, thanks) / mark
>
>
>Dan Mauch wrote:
>
>> From: "Dan Mauch" <dmauch@...>
>>
>> I use the US Digital linear encoder strips mounted in a 1X2 rectangular

tube

>> the length of the strip. I use a tube as a pushrod and as the conduit for
>> the encoder cables. Works slick.
>> I will be ordering board tomorro. Better let me know if you want a board.
>> Dan
>> -----Original Message-----
>> From: Buchanan, James (Jim) <jambuch@...>
>> To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
>> Date: Wednesday, May 26, 1999 6:08 PM
>> Subject: Re: [CAD_CAM_EDM_DRO] DRO boards
>>
>> >From: "Buchanan, James (Jim)" <jambuch@...>
>> >
>> >Tom:
>> >
>> >I am just new to the list so I missed out on some earlier discussion of
>> >your DRO project. I scanned your WEB page, I think it was yours, But I
>> >seemed to have missed what type of encoders you are using and or
>> >support. How about building your own using a type setter to make a film
>> >grid.
>> >
>> >Thanks
>> >--
>> >James Buchanan
>> >Lexington, Kentucky (The Blue Grass State) USA
>> >Two Truck Climax Locomotive Operator & Builder
>> >
>> >------------------------------------------------------------------------
>> >ONElist: where real people with real interests get connected.
>> >http://www.onelist.com
>> >Join a new list today!
>> >------------------------------------------------------------------------
>> >welcome to CAD_CAM_EDM_DRO@..., an unmodulated list for the
>> discussion of shop built systems in the above catagories.
>> >
>>
>> ------------------------------------------------------------------------
>> ONElist: where the world talks!
>> http://www.onelist.com
>> Join a new list today.
>> ------------------------------------------------------------------------
>> welcome to CAD_CAM_EDM_DRO@..., an unmodulated list for the

discussion of shop built systems in the above catagories.

>
>
>------------------------------------------------------------------------
>It's finally here! What's your opinion?
>http://www.onelist.com
>Create a Star Wars discussion group at ONElist.
>------------------------------------------------------------------------
>welcome to CAD_CAM_EDM_DRO@..., an unmodulated list for the

discussion of shop built systems in the above catagories.

>