Re: [CAD_CAM_EDM_DRO] Anilam Conversion
Posted by
Jon Elson
on 2002-07-12 23:56:25 UTC
elite_toolmfg wrote:
Bridgeport BOSS-7 and Ez-Trak machines.
supplies. You should be able to hook up a servo-to-go card or my PPMC
cards to drive the servo amps, and read the encoders.
See http://pico-systems.com/PPMC.html for more info on my
servo card set.
Jon
> I've posted questions and answers to this group but have never seenThese are very high quality servo motors, the same used on late-model
> them. I'll try again. I know I contacted some of you before but I'm
> looking for more on my options.
> I have a knee mill with Anilam Crusader M controller. I don't know
> if the motors are stepper/servo, but the tag reads as follows: MT30M4-
> 59, S/N:G10050, Const Stall Torque:3Nm, Max RPM:2400, Volts:140,
> Pulse Amps:30, Tacho:9.5 volts/1000rpm, made by SEM in England. Can
> someone please help me to decifer these motors?
Bridgeport BOSS-7 and Ez-Trak machines.
> What can I keep/getI think this may have Westamp servo amps already in it, including the power
> rid of? Some say redo whole thing, some say just add this or that.
> My problems is that I'm not quite as schooled as most of this group
> on the electronic componenets. I understand you need a power supply,
> motor drivers, motor driver amplifiers, motors and control software.
supplies. You should be able to hook up a servo-to-go card or my PPMC
cards to drive the servo amps, and read the encoders.
See http://pico-systems.com/PPMC.html for more info on my
servo card set.
Jon
Discussion Thread
elite_toolmfg
2002-07-12 12:59:48 UTC
Anilam Conversion
Jon Elson
2002-07-12 23:56:25 UTC
Re: [CAD_CAM_EDM_DRO] Anilam Conversion
Raymond Heckert
2002-07-13 17:49:16 UTC
Re: [CAD_CAM_EDM_DRO] Anilam Conversion