Re: [CAD_CAM_EDM_DRO] Re: Cutting a totem Pole
Posted by
Jon Elson
on 2002-08-09 20:24:50 UTC
rainnea wrote:
has already put their driver on the CD.
I have a parallel port motion control system that runs 4 steppers from
a board. These boards can be daisy-chained on the parallel-port bus,
so you can run quite a number of them from one parallel port.
See http://pico-systems.com/univstep.html for more info.
This is now supported by the EMC BDI version 2-12.
Jon
> Is it possible to drive more than 4 axes from one parallel port withTheoretically, yes. But, I think you have to modify the code, unless someone
> EMC ?
has already put their driver on the CD.
I have a parallel port motion control system that runs 4 steppers from
a board. These boards can be daisy-chained on the parallel-port bus,
so you can run quite a number of them from one parallel port.
See http://pico-systems.com/univstep.html for more info.
This is now supported by the EMC BDI version 2-12.
Jon
Discussion Thread
vrsculptor
2002-08-06 11:42:46 UTC
Cutting a totem Pole
caudlet
2002-08-06 12:06:28 UTC
Re: Cutting a totem Pole
imserv1
2002-08-06 14:23:14 UTC
Re: Cutting a totem Pole
allan_reinhard
2002-08-06 14:28:33 UTC
Re: Cutting a totem Pole
vrsculptor
2002-08-06 16:14:52 UTC
Re: Cutting a totem Pole
rainnea
2002-08-06 16:55:08 UTC
Re: Cutting a totem Pole
allan_reinhard
2002-08-06 17:13:32 UTC
Re: Cutting a totem Pole
Matt Shaver
2002-08-06 20:43:17 UTC
Re: [CAD_CAM_EDM_DRO] Re: Cutting a totem Pole
Les Watts
2002-08-07 07:30:11 UTC
Re: [CAD_CAM_EDM_DRO] Cutting a totem Pole
Ray Henry
2002-08-07 08:09:10 UTC
Re: Re: Re: Cutting a totem Pole
rainnea
2002-08-07 23:58:22 UTC
Re: Cutting a totem Pole
Ray Henry
2002-08-08 13:26:47 UTC
Re: Re: Cutting a totem Pole
rainnea
2002-08-08 13:52:04 UTC
Re: Cutting a totem Pole
Jon Elson
2002-08-09 20:24:50 UTC
Re: [CAD_CAM_EDM_DRO] Re: Cutting a totem Pole