Re: [CAD_CAM_EDM_DRO] PCI Printer Ports

Hi Gregg,

I successfully use a PCI parallel port board, SIIG's. It shows up at
C400h under windows, so I set my controller's port to that address. I
DON'T run under windoz, rather, I reboot in DOS. This implies that no
"set up" of the board was needed, just the port's address block.

Alan KM6VV

ghartc wrote:

>
> Is anyone having any problems, or any luck, getting pin-by-pin
> control of PCI type printer ports? I have a couple that want
> to appear at odd adresses like "3468" vs. the usual "278/378/3BC"
> that most control programs use.
>
> I just haven't been able to control those ports so far. This
> is WinXP, which doesn't make it any easier.
>
> Any ideas?
>
> Thanks, Gregg