Re: [CAD_CAM_EDM_DRO] inlays

I'd have to second Chris on this, I no longer use any CAD/CAM programs, just
Signlab.
(In the interest of full disclosure, I am a Signlab dealer, though it wasn't
until after I
used Signlab for a few years before I became a dealer)


Erie Patsellis
Shelbyville Design & Signworks
1309 W. S. 7th Street
Shelbyville, IL 62565
(217)774-4444
visit our website at www.shelbyvilledesign.com

----- Original Message -----
From: "CL" <datac@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Friday, August 30, 2002 8:09 AM
Subject: Re: [CAD_CAM_EDM_DRO] inlays


> After having been exposed to some of the $7000 and up Cad/Cam packages,
I'd pick Signlab over the rest for Inlay work. You can draw the "hole" for
the veneer and create both the pocket and the plug
> with very few steps. Not only can you instantly adjust for a few
thousandths "gap" between the two, but you can also choose to install a
"glue tray" around the edge of the pocket, where the glue can
> settle in because it cuts a little deeper on the outside pass.