Re: [CAD_CAM_EDM_DRO] Servo to go card's, RUTEX
Posted by
Jon Elson
on 2002-08-30 10:50:11 UTC
Alan Marconett KM6VV wrote:
direct to the ISA bus, so the IEEE-1284 protocol is not needed.
The basic info on the board is on their web site for download, as far as
I remember. You also need to get the info on the encoder chips from
US Digital. The STG board just brings the functions of the encoder
chip out to the ISA bus. The DAC and DIO are pretty simple, and
the STG manual should be sufficient documentation.
Jon
> Jon,The servo to go board looks a lot like my board, except the connection is
>
> Actually, I was asking if you happened to know about the "servo to go"
> board commands. But thanks for the info on your boards.
>
direct to the ISA bus, so the IEEE-1284 protocol is not needed.
The basic info on the board is on their web site for download, as far as
I remember. You also need to get the info on the encoder chips from
US Digital. The STG board just brings the functions of the encoder
chip out to the ISA bus. The DAC and DIO are pretty simple, and
the STG manual should be sufficient documentation.
Jon
Discussion Thread
Alan Marconett KM6VV
2002-08-28 10:17:10 UTC
Re: [CAD_CAM_EDM_DRO] Servo to go card's, RUTEX
Jon Elson
2002-08-28 17:54:17 UTC
Re: [CAD_CAM_EDM_DRO] Servo to go card's, RUTEX
Jon Elson
2002-08-28 18:02:26 UTC
Re: [CAD_CAM_EDM_DRO] Servo to go card's, RUTEX
Alan Marconett KM6VV
2002-08-28 18:19:52 UTC
Re: [CAD_CAM_EDM_DRO] Servo to go card's, RUTEX
Carol & Jerry Jankura
2002-08-28 19:40:16 UTC
RE: [CAD_CAM_EDM_DRO] Servo to go card's, RUTEX
Jon Elson
2002-08-29 00:31:08 UTC
Re: [CAD_CAM_EDM_DRO] Servo to go card's, RUTEX
Jon Elson
2002-08-29 00:40:15 UTC
Re: [CAD_CAM_EDM_DRO] Servo to go card's, RUTEX
Alan Marconett KM6VV
2002-08-29 10:16:21 UTC
Re: [CAD_CAM_EDM_DRO] Servo to go card's, RUTEX
Jon Elson
2002-08-29 20:15:22 UTC
Re: [CAD_CAM_EDM_DRO] Servo to go card's, RUTEX
Alan Marconett KM6VV
2002-08-29 20:28:19 UTC
Re: [CAD_CAM_EDM_DRO] Servo to go card's, RUTEX
Jon Elson
2002-08-30 10:50:11 UTC
Re: [CAD_CAM_EDM_DRO] Servo to go card's, RUTEX
Alan Marconett KM6VV
2002-08-30 14:53:47 UTC
Re: [CAD_CAM_EDM_DRO] Servo to go card's, RUTEX