Re: "step and repeat " with Flashcut

Chris,Peter,and others
Thanks for replies.
I use MillWrite 2000 for CadCam and do create a lot of programs by
"duplicate" etc.
Having used cncpro for so long, I do most of my multiple parts as
subroutines in relative mode,using abs. to go to next fixture.
This is one of those applications where you may need to "tweak" a
single move on a part but don't want to go back to the drawing,
change a single line in the subroutine and 10sec later you are cutting
again. Or , maybe you need to shift the start pt on 1 of 24 identical
parts [but none of the others] without going back to the cadcam
software.
There is always a way,sometimes you give up one familiar method to
gain an improved feature .
thanks again
Carl